-
May 23, 2025304 Stainless Steel Yield Strength304 Stainless Steel Yield Strength: Typical yield strength (0.2% offset) for annealed 304 stainless steel is approximately 205 MPa (30,000 psi) . Cold worked conditions can incr... -
May 23, 2025304 Stainless Steel Melting Point304 Stainless Steel Melting Point Typical Melting Range: Approximately 1400°C to 1450°C (2552°F to 2642°F) It melts over a range due to its alloy composition, no... -
May 23, 202518 8 Stainless Steel Vs 304 Stainless Steel18-8 Stainless Steel vs 304 Stainless Steel 18-8 Stainless Steel is a general term describing stainless steels with approximately 18% chromium and 8% nickel content. 304 Stainle... -
May 23, 2025Is 304 Stainless Steel MagneticIs 304 Stainless Steel Magnetic? In its annealed (fully heat-treated) state, 304 stainless steel is generally non-magnetic because it has an austenitic crystal structure. Howeve... -
May 23, 2025304 Vs 316 Stainless SteelSummary: Choose 304 for general-purpose use with good corrosion resistance at a lower cost. Choose 316 when you need higher corrosion resistance, especially in chloride or marin...
-
May 23, 2025Incoloy 825 Welding ProcedureWelding Procedure for Incoloy 825 1. Preparation: Clean the base material to remove any contaminants, oil, grease, or oxides. Preheat is generally not required , but can be appl... -
May 23, 2025Incoloy 825 Vs Ss316Summary: Incoloy 825 is preferred for highly corrosive acid environments and high temperature, high strength needs, while SS316 is a versatile stainless steel suitable for gener... -
May 23, 2025Incoloy 825 Equivalent MaterialNote: While these are equivalents in terms of corrosion resistance and mechanical properties, exact composition and certification may vary by standard. -
May 23, 2025Incoloy 825 AstmIncoloy 825 is covered under several ASTM specifications depending on the product form: ASTM B423 - Seamless Nickel-Iron-Chromium Alloy 825 Pipe ASTM B424 - Welded Nickel-Iron-C... -
May 23, 2025Incoloy 825 HardnessIncoloy 825 Hardness Typical Hardness: Brinell Hardness (HB): 160 – 220 Rockwell Hardness (HRB): 80 – 95 (depending on heat treatment and condition) Influencing Fact... -
May 23, 2025Incoloy 825 DensityIncoloy 825 Density Typical Density: Approximately 8.0 g/cm³ (8000 kg/m³) Influencing Factors Chemical Composition: Slight variations in nickel, chromium, iron, copper...
-
May 23, 2025Incoloy 825 Chemical CompositionFeatures Excellent resistance to oxidation and corrosion in a wide range of severe environments. Outstanding resistance to hydrochloric acid, sulfuric acid, and phosphoric acid....
